Chapter 16 · 16.22
Placing a table next to your text, with text flowing around it
You might want a small table with opening hours, specifications or prices to the right of your text, just as you would place a photo with text wrapping. By default, a table sits between paragraphs and no text flows alongside it. A few settings turn it into a "flow table".
Step 1: make the table narrower
You need to leave space next to the table. Drag the right edge of the table to the left, or give the table a fixed width: right-click in the table, choose Table advanced settings and, on the Table tab, enter a Preferred width, for example 6 cm.
Step 2: text wrapping
- In the same window, go to the Wrapping tab.
- Choose Flow table (the image on the right) instead of Inline table.
- Under Distance from text, set how much space you want between the table and the text, for example 0.3 cm on all sides.

Step 3: set the position
Click OK. The table stays on the left and the text flows along its right side, as in the image. If you want the table on the right, open the window again and set the alignment under Horizontal on the Table position tab. Leave Move object with text ticked there: the table then stays with its paragraph when you add text above it.

You can now also drag the table with your mouse: grab it by the cross icon in the top left corner.
Pitfalls
- A flow table at the end of a page can slide over the footer, or it jumps to the next page and leaves a gap. If that happens, set it back to Inline table or move the paragraph it is attached to.
- Only use this for small tables. Leave a long table that runs across several pages inline.
- If the position needs to be exactly the same in Word, check the document in Word or send a PDF. Text that flows around an object comes out slightly differently in different programs.
